SlimSAS LP x8 (SFF-8654) to 8x SATA, 85 cm Cable for Dell H750/755
SlimSAS LP x8 (SFF-8654) to 8x SATA, 85 cm Cable for Dell H750/755
Bulk & OEM pricing available · Reply within 24 hours
Eight SATA drives from the low-profile SlimSAS port on a Dell PERC H750 or H755. This DiLinKer 85 cm cable starts at the LP (low-profile latch) variant of the SlimSAS 8x connector (SFF-8654 LP, 74-pin) — the plug used on Dell's 12G/24G RAID controllers — and fans out to eight standard SATA 7-pin plugs. It is the single-cable answer to "my PERC card has one SlimSAS port and my chassis has eight SATA bays".
Why this cable
- Made for Dell PERC H750 / H755. The LP latch variant mates the controller's SlimSAS port without adapters.
- Eight drives, one cable. Each of the eight lanes maps to one SATA drive through the fan-out.
- Up to 24 Gb/s per lane on SAS targets. SATA III drives run at their usual 6 Gb/s; SAS targets get the full link speed.
- 85 cm for 1U and 2U routing. Reaches the drive wall with a little slack for service loops.
- Replaces eight cables. One slim run instead of a fist of SATA cables in the airflow path.
Specifications
| Host connector | SlimSAS 8x LP, SFF-8654 LP, 74-pin plug |
| Device connector | 8 × SATA, 7-pin |
| Lanes | 8, one SATA drive per lane |
| Interface speed | Up to 24 Gb/s per lane (SAS); SATA III drives at 6 Gb/s |
| Protocol | SATA target drives |
| Cable length | 85 cm / 33.5 in |
| Part number | DL-3143 |
| SKU | B0B5CRTG52 |
| Warranty | 12 months |
Compatibility
Works with
- Dell PERC H750 and H755 RAID controllers (SlimSAS LP port).
- Other controllers that use the same SFF-8654 LP 74-pin plug.
- SATA III drives and SATA backplane ports as targets.
Does not work with
- Controllers with a standard-height SlimSAS plug or a MiniSAS HD port — the LP variant will not mate with them.
- NVMe drives. This assembly carries SAS/SATA protocol, not PCIe.
- The SATA ends as host ports — they are targets and must go to drives.
Typical deployments
- Dell server rebuild. H750/H755 to eight SATA bays with one cable.
- Storage upgrade. Add SATA capacity to a PERC-based server without a new controller.
- Airflow-critical chassis. One flat run instead of eight round cables across the fans.
Frequently asked questions
Will this fit my Dell controller?
It is built for the SlimSAS LP port used on PERC H750 and H755. If your controller is a different model, check whether it uses the same LP 74-pin plug — or send us the model and we will confirm.
Can I connect SAS drives instead of SATA?
The fan-out ends are standard SATA 7-pin plugs, so the target side is SATA equipment. For SAS drives with SFF-8482 connectors, use a SlimSAS to 8×SAS cable.
Do the drives need separate power?
Yes — this is a data cable. Drives take power from the PSU or backplane as usual.
Is the LP connector different from normal SlimSAS?
The pinout and signals are the same; the housing and latch are lower-profile so the plug clears the shroud around Dell controller ports. A standard SlimSAS plug will not latch correctly on these cards.
In the box
- 1 × SlimSAS LP x8 to 8 × SATA cable, 85 cm (SKU B0B5CRTG52)
Backed by a 12-month warranty. If a link trains at reduced width or does not appear, contact us with your controller and device models and we will help you isolate the cause.
Related
Share
